SpeedFactory Racing 4 Bar Map Sensor K Series K20 K24 Black Horns Resuable with no difficult and

Resuable with no difficult and messy mating surface cleanup required

The SpeedFactory Racing B-Series AWD Offset Reverse Shaft is needed if you are trying to use a mid '00-'01 PBW2 AWD B-Series Outer Transmission Housing with a billet bellhousing (all currently known billet bellhousings are PBW1 based) because the reverse gear ratio and shaft spacing was moved in the mid '00-'01 housings

Real carbon fibre with red twill weave

With the use of a specialized air filter cleaning solution and low-pressure water

SpeedFactory Racing 4 Bar Map Sensor K Series K20 K24 Black Horns Resuable with no difficult andOur SpeedFactory 4 Bar MAP sensors use state of the art bipolar op amp circuitry with thin film resistor networks built into each microchip. Pressure changes are calculated on a true linear 05 volt scale via a specially designed silicon pressure sensor that also compensates for temperature changes. The unique ability to compensate for temperature changes allows our MAP sensor to remain a minimum of 99% accurate from 32 degrees F to 180 degrees F