Silicone Mould - 6PC Butterfly - S100 mudcake This embosser design comes in

This embosser design comes in 60mm

Embossers can be stamped up to 2mm in depth

(please note this set does NOT include the mould to create the bow)

Suitable for dusting

Silicone Mould - 6PC Butterfly - S100 mudcake This embosser design comes inInstructions: For the best details, lightly dust the mould with cornflour or icing sugar. Press in small amount of sugar paste, gumpaste or fondant, roll gently over the silicone mould with the rolling pin and remove the excess paste with the sharp knife. Tip: For a easy release, put the mould in a freezer for about 30 seconds, or bit longer if needed. Once the gum paste has hardened up a bit, turn the mould over, and the item should pop out easily.